ADVERTISEMENT
1. Fix a Leaky Dishwasher
A leaky dishwasher can be a nuisance, but it’s often an easy fix. First, check the door gasket for any cracks or damage. The gasket is a rubber seal that runs along the edge of the dishwasher door. If it’s worn out, water can seep through. Replacing it is simple: remove the old gasket by pulling it out of the groove, and press the new one into place, ensuring it’s snug and secure.
Another common cause of leaks is a clogged or faulty drain hose. Inspect the hose for any kinks or blockages. If it’s clogged, detach it from the dishwasher and clean it out using a long brush or a piece of wire. Reattach the hose securely to prevent future leaks.
2. Unclog a Washing Machine Drain
If your washing machine isn’t draining properly, the drain hose or pump filter might be clogged. Start by unplugging the machine and turning off the water supply. Locate the drain hose at the back of the machine and detach it. Use a long, flexible brush to clear any blockages.
Next, check the pump filter, usually located at the bottom front of the machine. Open the access panel and unscrew the filter cap. Remove any debris or lint trapped inside, then screw the cap back on securely. Reattach the drain hose, and your washing machine should drain properly again.
3. Replace a Refrigerator Water Filter
Replacing a refrigerator water filter is a straightforward task that ensures your water and ice remain clean and fresh. Most filters are located inside the refrigerator, either in the upper right corner or behind the grille at the bottom.
To replace the filter, turn off the water supply and twist the old filter counterclockwise to remove it. Insert the new filter by twisting it clockwise until it locks into place. Turn the water supply back on and run a few gallons of water through the dispenser to flush out any air and impurities.
4. Clean a Stovetop Burner
Over time, stovetop burners can accumulate grease and food debris, affecting their performance. To clean them, first ensure the burners are cool and then remove them from the stovetop. Soak the burners in a mixture of warm water and dish soap for about 20 minutes to loosen any grime.
Use a non-abrasive scrubber to clean the burners thoroughly. For stubborn spots, a paste made of baking soda and water can be applied and scrubbed gently. Rinse the burners with clean water and dry them completely before reattaching them to the stovetop.
5. Tighten a Loose Oven Door Handle
A loose oven door handle can be annoying but is easy to fix. Open the oven door and locate the screws that secure the handle, usually found on the inside of the door. Using a screwdriver, tighten these screws until the handle is secure.
If the screws are stripped or damaged, replace them with new ones of the same size. Ensure the handle is aligned properly before tightening the screws to avoid any misalignment.
6. Clear a Vacuum Cleaner Blockage
A vacuum cleaner that isn’t picking up dirt effectively might have a blockage. Start by unplugging the vacuum and checking the hose for any obstructions. Detach the hose and use a broom handle or similar object to push out any debris.
Next, inspect the brush roll for tangled hair or fibers. Use scissors to carefully cut away any entangled material. Finally, check the vacuum bag or canister and empty it if full. Reassemble the vacuum and test it to ensure it’s working properly.
see continuation on next page
ADVERTISEMENT